中小企業のための商社だ。少ロットや特殊サイズや素材などを理由に、日本国内入手困難な製品の調達も可能。

Dynatect　Gortite Way Wiper Variety

Hundreds of standard profiles to choose from.
Capable of accommodating complicated guide way designs.
Can manufacture custom profiles, if required.

Low-Cost Tooling

Low-cost tooling for compression molded wipers (long-term hard tooling)
Due to our wide selection of existing designs, tooling, and standard profiles, there are cases where custom-fabricated wipers may be manufactured without tooling requirements.
Wiping Surface Material

All standard offerings use Nitrile/NBR (Buna-N Rubber) which is a standard industry material and provides the following advantages:
Higher compatibility with a wider variety of cutting fluids and coolants used in typical applications including the use of synthetic fluids.
Improved resistance to abrasion, oil, and hydraulic fluids.
Lower coefficient of friction (compared to standard urethane designs).
Superior performance in “dry” machining applications.
Improved performance in both wet and dry wiping applications. NO CHATTER.
Better finish appearance (better wiping surface).
If the application requires, Dynatect offers the use of FPM, fluoroelastomer performance rubber, which is highly resistant to acids and extreme high temperatures upwards of 410° Fahrenheit. (210° Celsius).

DYNATECT Gortite way wipers
Dynatect stock wipers save costly maintenance, reduce downtime, and prolong the service life of machine tool ways. These stock wipers are molded from abrasion and oil-resistant nitrile/Buna-N elastomer.
All four types come in standard 22" lengths, which can be cut to required lengths. Over sized holes for screws can be drilled in wiper to adjust wiper closer to the way surface to extend service life.

• Type A (Part No. 220001)
  • Metal enclosed molded wiper with a finger spring to act as a chip guard.
    • The metal insert is 20 ga. galvanized steel and the guard is .01 in. thick spring steel.
• Type B (Part No. 220002)
  • Molded wiper with metal strip bonded to one side.
    • The metal insert is 20 ga. galvanized steel.
• Type C (Part No. 220003)
  • Molded wiper only.
    • Metal mounting plate recommended.
• Type D (Part No. 220004)
  • Molded wiper with light metal strip which acts as finger spring and chip guard.
    • The metal insert is 20 ga. galvanized steel and the guard is .01 in. thick spring steel.

製品紹介